Repair & maintenance guides

The Real Cost of Owning a Boat: Building a Yearly Budget and Cutting Costs with DIY

Add up what a boat really costs each year (storage, insurance, fuel, maintenance, winterizing, registration, depreciation and the surprise repair), check it against the common rules of thumb, and find the places where do-it-yourself work and smarter choices save real money. Practical planning help, not financial advice.

Tilting an Outboard or Sterndrive by Hand: Using the Trim Manual Release Valve

When the power trim quits, a small release valve on the trim unit lets you raise or lower the motor by hand, so you can get off a sandbar, load the trailer or get home. Learn where to find it, how far to open it, how to lift and support the motor safely, and why it must be closed again before you run.

Tow Ropes, Tubes and Watersports Gear: Inspect, Rig and Retire

Check ski, wakeboard and tube ropes, handles, towable tubes and your boat's tow points before every outing, rig them the right way, and know when to throw gear out. Includes the safety basics (spotter, flag, life jackets, prop and carbon monoxide) that vary from state to state.

Tow Vehicle Maintenance for Boat Owners (Transmission, Differential, Brakes, Hitch)

Keep the truck or SUV that pulls your boat ready for the job: follow the severe-service schedule, protect the transmission from heat, check the rear differential for ramp water, keep brakes, tires, hitch and wiring in shape, and rinse salt off the underside after every saltwater launch.

Tow Vehicle Rear Differential Care: Ramp Water, Milky Gear Oil and Limited-Slip Additive

Backing the truck's rear axle into the water at the launch ramp can pull water into the differential through its vent. Learn how water gets in, how to keep the axle dry, how to drain and read the gear oil, why limited-slip axles need friction modifier, when to change the fluid, and when the differential needs a shop.

Towable Tube Care and Repair: Find Leaks, Patch the Bladder and Know When to Retire It

Inspect a towable tube's bladder, cover, valves, handles and tow point, find and patch leaks the right way, and dry and store it so it lasts. Also covers rider ratings and the damage that means the tube should be retired, not repaired.

Towing a Wide or Heavy Boat: Width Limits, Oversize Permits and When to Hire a Hauler

In most states a boat or trailer wider than 8 feet 6 inches (102 inches) is a wide load that needs a permit, and some loads also need flags, signs, lights, set travel hours or escorts. Learn how to measure your rig, find each state's rules, get the permits and decide when a professional transporter makes more sense.

Trailer Tongue Jack and Coupler Care: Grease, Adjust and Know When to Replace

The tongue jack and coupler take a beating from weight, road grit and launch-ramp dunking. A few minutes of cleaning and grease a couple of times a season keeps the jack cranking smoothly and the coupler locking tight on the ball, and tells you when either part is worn out.

Transom Savers and Motor Supports: How to Trailer Your Outboard or Sterndrive

Potholes and driveway dips put real load on the transom, the tilt system and the engine bracket. Learn when engine makers want a support, why the tilt support lever is not one, how to choose and fit a transom saver or trim-ram support, and what goes wrong when it's fitted badly.

Trim Gauge Reads Wrong or Not at All: Testing and Replacing the Trim Sender

When the trim gauge sticks at full up, reads backward or jumps around, the cause is usually the sender at the engine, a corroded wire or a bad ground, not the gauge. Learn how the sender works, how to test the gauge and sender with a meter, how to adjust or calibrate it, and when replacement is a shop job.

Trim Leaks: When the Motor or Drive Won't Stay Up

Track down why your outboard or sterndrive slowly sinks, trails down on the trailer or leaks trim fluid. Work from the free checks (release valve, fluid level) to hoses, ram seals and internal leaks, and learn when a rebuild or a new cylinder makes more sense.

Trolling Motor Won't Run, Runs Weak or Cuts Out: How to Troubleshoot It

Work through a dead, weak or on-and-off trolling motor from the cheapest checks to the hardest: battery charge and load test, connections, the breaker, line wrapped behind the prop, stow and deploy problems and GPS anchor glitches. Most problems turn out to be power supply; motor head and steering electronics are a service-center job.

Two-Stroke Oil Injection vs. Premix: How It Works and How to Check It

A two-stroke engine dies quickly without oil in its fuel, so the oil injection system and its alarms deserve regular attention. Learn how injection and premix differ, what the warning horn is telling you, how to check the system, how to premix safely using your manual's ratio, and the real risks of disabling injection.

Two-Stroke Premix Conversion: Living With an Engine That Had Its Oil Injection Removed

Bought a two-stroke outboard or PWC whose oil injection was removed, or thinking of doing it? Learn how to confirm what was done, mix fuel at the ratio from your manual every single time, label your tanks so nobody forgets, choose NMMA TC-W3 oil and understand the real risks.

Two-Stroke Smoking More Than Usual - Troubleshooting Guide

Tell normal two-stroke smoke from a warning sign, then work through the usual causes in order, from the oil mix and choke to spark plugs, oil injection, carburetor and overheating, and know when to shut down.

Type I and II Treatment Systems (Electroscan, Purasan, Lectra/San): Care, Salt, Tablets and Winter

A flow-through treatment system lets a boat discharge treated waste where the law allows, but only if it works and only outside no-discharge zones. Learn how these units work, why salt and tablets matter, how to keep electrodes and dispensers clean, how to lock the system in a no-discharge zone, and how to lay it up dry for winter.

Underwater LED Lights: Care, Leaks, Corrosion, Wiring and the Rules

Keep underwater LED lights bright and your hull dry. Learn the difference between through-hull and surface-mount lights, how to clean growth off the lens without damaging it, what to check for leaks, wiring, fusing and bonding, when the boat has to be hauled, and why the lights should not be on while you're underway.

Upgrading Boat Trailer Hubs: Grease-Through Spindles, Oil Bath, Protectors and Pre-Packed Kits

Choose the right hub setup for how you use your trailer, swap in a pre-packed hub kit, adjust it correctly and know when the axle itself is the real problem. Better hubs mean fewer roadside bearing failures and less time with greasy hands.

USCG Documentation Renewal: When, How, What It Costs and How to Avoid Look-Alike Renewal Mailers

Keep your boat's Coast Guard Certificate of Documentation current: how long a recreational certificate lasts (1 to 5 years), the federal fee schedule, renewing directly with the NVDC online, what happens if it lapses, why many states still want registration and a decal, and how to spot the third-party letters that charge several times the real fee.

USCG Required Safety Equipment Check by Boat Length

Walk through your boat and confirm you carry every piece of safety gear the US Coast Guard requires for your boat's length and type, and that none of it is expired or worn out. Missing or expired gear is one of the most common tickets on the water, and it is the gear you need when things go wrong.

Used Boat Paperwork: Titles, Liens, HIN Checks, Bill of Sale and Registration

A practical checklist for the paperwork side of buying a used boat: state title or Coast Guard documentation, checking for liens and theft, verifying the hull ID number, writing a proper bill of sale, the trailer's own title, registering in your name, and transferring warranties and checking recalls. Rules vary by state, so confirm each step with your state agency.

Used Boat Purchase Agreement and Closing: Deposit, Contingencies, Bill of Sale and Who Pays What

A plain-English walk-through of buying a used boat on paper: getting ready before you offer, what the purchase and sale agreement should say, how the deposit is held and when it comes back, survey, sea trial, financing and insurance contingencies, paying off the seller's loan, the bill of sale, closing and transferring the paperwork, and the costs each side usually covers. Practical help, not legal advice; rules vary by state.

Using a Pontoon Boat in Salt Water: Tubes, Anodes, Flushing, Rinsing and Copper-Free Bottom Paint

Keep an aluminum pontoon alive in salt or brackish water: protect the tubes and hardware from corrosion, use the right anodes, flush the outboard the correct way, rinse the deck, furniture and trailer, cover only when dry, and never let anyone put copper-based (cuprous oxide) bottom paint on aluminum tubes.

Vapor Lock and Hot Restarts: Why Your Boat Won't Start After a Stop on a Hot Day

On hot days, fuel can boil into vapor in the lines, carburetor or fuel system after you shut down, so the engine cranks but won't start, or starts and dies after a fuel stop. Learn how to recognize heat soak, restart a hot engine the right way, and reduce the problem with fuel choices, ventilation and line routing.